CRIMP TOOL

Tool Adjustment

Incorrect adjustment can cause under-crimping and failure of the joint.

  1. Crimp joint and test with gauge.
  2. If gauge passes easily over crimped ring, the tool settings are satisfactory.
  3. If gauge does not pass easily over the ring, then adjust as follows:
    • With jaws in the open position, slacken off the lock nut and turn the adjusting bolt clockwise in small increments. (1/4 to1/2 a turn only)
    • Repeat steps 1 and 2 with new joint.
    • When satisfactory, re-tighten lock nut.
  4. Check regularly and adjust tool as necessary